Introduction to AquaMotion Hot Water Recirculation

The Comfort and Savings of Instant Hot Water with Recirculation

Hot Water Recirculation Systems: For Retrofit & New Construction

The Problem

How long do you wait for hot water when you turn on the faucet? 30 seconds, 1 minute, 2 or 3 minutes, longer? While you wait, a home with 5 taps can waste up to 15,000 gallons of tempered water down the drain. You pay for this potable water, wasted energy and sewage fees.

The Solution

Install a proven, awarded AquaMotion recirculation system. One system is available for every type of installation, hot water tanks or tankless.

The Benefits

Hot Water Comfort at Every Faucet
Save Time, No More Waiting For Hot Water
Save Hot Water, 12,000 – 15,000 Gallons a Year
Save Energy with Timer, Save on Utility and Sewer Bills
Save More with “ON DEMAND” Systems
Go Green, Help Conserve this Precious Water Resource
Meet local Plumbing Codes

The Cost

To run the circulator with timer at $0.12 per kw is approx. $3.00, $8.00 for the large pump annually. Our hot water recirculation kits have an approx. one to three year payback depending on the size of the installation.

How Does It Work?

A pump at the tank or tankless heater, or installed under the sink, forces the lukewarm water from the hot supply line into the cold supply line. If a dedicated return line is used it returns the lukewarm water to the heater.

A sensor/switch (Aquastat) built into the pump or an Aqua-Flash® or ODR Superflow™ By-pass valve transfers the lukewarm water into the cold pipe. The valves maintain average 93° F (34° C) at the sink. The under sink pump starts when temperature drops to 85° F (30° C) and stops when it reaches 104° F (40° C). The pump runs about 3 times an hour for 2 minutes. A built-in 24-hour mechanical timer allows the user to set the time when he wants instant hot water. An ON DEMAND button/motion sensor or app can also activate the system


Share this post

← Older Post Newer Post →