Heat Fab 9814 Saf-T Vent EZ Seal - 8 Inch Diameter - 90 Degree Elbow

$224.00 $157.95
(You save $66.05)
Usually Ships Same Day if ordered by 1pm CST Mon-Fri
Saf-T Vent EZ Seal
Product Type:
Pipe Diameter:
Elbow Degree:
90 Degrees

Need Some Advice? Speak to one of our associates now!



Heat Fab 9814 Saf-T Vent EZ Seal - 8 Inch Diameter - 90 Degree Elbow
Heat Fab Saf-T Vent EZ Seal is the fastest and most reliable venting solution for Category I, II, III, and IV gas appliances – with no RTV sealant required. Saf-T Vent venting systems are designed for optimal corrosion resistance. This enables the safe and reliable operation of fuel-efficient appliances in demanding applications. Ideal for venting modern mid- and high-efficiency gas-fired equipment such as furnaces, boilers, large modular systems, water heaters, tankless units and more.
90° Elbow- Use to achieve offsets or changes in the direction of the vent system. The degree of these welded seam elbows is not adjustable.
HeatFab Saf-T Vent Seal speeds installation on jobs since no curing is required. The special seal allows the appliance to be started as soon as the installation is complete. All joints in the Saf-T Vent EZ Seal system are fastened with the patented Ring and Tab tapered closure system and sealed with factory applied seal.


  • Heat Fab 9814
  • 8" Diameter
  • 90 Degree Elbow
  • Saf-T Vent EZ Seal
  • AL29-4C Stainless Steel
  • Easy to install, because the seal's built right in
  • Engineered for fast, secure installation
  • Reliable performance


EZ Seal Catalog & Dimensional Data
HeatFab Spec Sheets EZ Seal Brochure
HeatFab Weight Heatfab Weight Per Foot
View Adapter Chart

EZ Seal Install (3" to 5")
EZ Seal Install (6" to 16")


Selkirk Corporation warrants to the original homeowner or ultimate purchaser that all Saf-T Vent products (EZ Seal, SC, GC & CI Plus) will be free from defects in material or workmanship when properly installed pursuant to the manufacturer’s installation instructions and the appropriate building codes. Selkirk will, at its option: repair, replace or provide a full refund for all of its parts or components found to be defective or not in conformance with this limited warranty. Any defect arising from the improper installation, operation or maintenance of this system and/or connected appliance(s) is not covered by this warranty.

In order to obtain warranty service, the consumer must give prompt written notice of any defect to Selkirk following notice of the defect, and within Fifteen (15) years from the date of installation. Please notify:

Selkirk Corporation 1301 W. President George Bush Hwy. Suite 330 Richardson, TX 75080

Selkirk Canada Corporation 375 Green Road Stoney Creek, ON L8E 4A5

Selkirk is not responsible for the cost of inspecting, removing or reinstalling the parts subject hereto, nor shall it be liable for any special, incidental or consequential damages or expenses incurred by the consumer or its contractors. However, Selkirk reserves a right to reimburse reasonable and direct product reinstallation costs provided it agrees in writing to such costs in advance of those costs being spent by a claimant.

The warranty on any replacement part shall be for the unexpired term of the original warranty.

Some states do not allow for the exclusion of incidental and consequential damages, so the limitations above may not apply to you.

Related Products

Questions & Phone Orders

SDS Supply Corp.
13731 S. Route 30, Unit 105
Plainfield, IL 60544
Call us: (800) 236-9029

Shop with Confidence

Safe & Secure shopping online. Learn more

Payment Methods